Newer
Older
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
hdmi_force_hotplug=1
# Additional overlays and parameters are documented /boot/overlays/README
# Configure cabinet buttons
dtoverlay=picade
dtparam=up=17 # W
dtparam=down=31 # S
dtparam=left=30 # A
dtparam=right=32 # D
dtparam=button1=22 # U
dtparam=button2=23 # I
dtparam=button3=24 # O
dtparam=button4=36 # J
dtparam=button5=37 # K
dtparam=button6=38 # L
dtparam=enter=28 # Enter Key
dtparam=escape=1 # Escape Key
dtparam=coin=42 # Left Shift
dtparam=start=29 # Left Control
# Enable audio (loads snd_bcm2835)
dtparam=audio=on
# Automatically load overlays for detected cameras
camera_auto_detect=1
# Automatically load overlays for detected DSI displays
display_auto_detect=1
# Enable DRM VC4 V3D driver
dtoverlay=vc4-kms-v3d
max_framebuffers=2
# Run in 64-bit mode
arm_64bit=1
# Disable compensation for displays with overscan
disable_overscan=1
[cm4]
# Enable host mode on the 2711 built-in XHCI USB controller.
# This line should be removed if the legacy DWC2 controller is required
# (e.g. for USB device mode) or if USB support is not required.
otg_mode=1
[all]
[pi4]
# Run as fast as firmware / board allows
arm_boost=1
[all]